Product no.: 01486
425,00 EUR per kg Coral glue for attaching coral scions to scion stones.
Instruction manual:
Quick Start Guide :
Have rubber gloves, paper towels, and MarinStick ready Place scion stone ready and put on rubber gloves.
Remove the coral scion from the water
Dab the broken part of the coral limb dry with paper towel. Apply 1 to 3 drops (depending on the size of the fracture area) of MarinStick adhesive to the intended adhesive area of the scion stone. Apply the fracture surface of the coral limb to the gluing site and hold it in place for approx. 10 seconds with light pressure. Place the finished coral scion back into the aquarium.
Carefully clean the MarinStick glue nozzle with a paper towel and close it tightly again.
CoralStick Instructions for Use :
First of all, some important information on the use of the CoralStick.
Basic information before use:
The tube is sealed and MUST be opened before first use. To do this, unscrew the plastic cap and push the upper end into the tube. Then quickly screw the plastic cap back onto the tube.
Now unscrew the top of the plastic cap and cut off a very small piece at the tip. Please really only minimally, because this is the only way to prevent the opening from becoming too large and to make the best possible use of the adhesive fluid outlet. Please do not press the tube too hard, otherwise too much of the adhesive fluid will run out.
Recommendation:
It is recommended to wear protective gloves when working with the adhesive!
Fixing fragments:
Remove the corals you want to fragment and break off the corresponding pieces with a suitable pair of pliers. Put a stone with the right size on it and put a small amount of glue on the previously broken off piece. Now place the scion on the scion stone, hold it firmly and immerse it in salt water for 10 seconds (while continuing to hold it). Now remove the stone with the fragment from the water and then carefully place it there to harden for another 60 seconds in peace. Only now, the thus produced stone is placed in the aquarium or in a previously prepared container for final hardening.
After about 5 minutes, the stone can be placed in its final location.
Hazard warnings:
- Keep away from children and store out of reach!
- Avoid contact of the glue with skin and eyes.This new glue has been tested by many well-known aquarists and found to be very good.
Even the green 'Enzmann' Acropora, which is considered to be very sensitive, has been tested and found to be very good. Acropora, which always caused problems with freshly broken fragments, can be processed immediately with this glue. Immediate bonding without tissue damage is possible and cures under water. Furthermore, the smallest amounts of adhesive are now required and is therefore very economical. In seconds you have offshoots with a natural appearance.
Content: 20gram
ATTENTION !
Contains Ethyl-2-cyanoacrylate
Hazard statements:
H315 Causes skin irritation.
H319 Causes severe eye irritation.
H335 May cause respiratory irritation.
Precautionary statements:
P102 Keep out of the reach of children.
P261 Avoid breathing mist/vapor/aerosol.
P271 Use only outdoors or in a well-ventilated area.
P280 Wear protective gloves/protective clothing/eye protection.
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove any contact lenses if possible. Continue to rinse.
P312 If you feel unwell, call a POISON CENTER/doctor.
P405 Keep locked up.
P501 Dispose of contents/container to hazardous waste collection point.
Special labelling
EUH202 Cyanoacrylate. Hazard. Adheres to skin and eyelids within seconds. Keep out of the reach of children.
German
English